THE STEVENS DEVICE: ENERGY FROM COILS OF WIRE AND A MAGNET
Here is what we know so far.
1. Our email to request more information from our contacts;
2. An edited email response from one investigator; and
3. A telephone response from another investigator.
INE email sent: 5:27 PM, 12/30/96:
To: Energy_Sent_List From: firstname.lastname@example.org (Patrick Bailey) Subject: Wanted: Info on the New Earth Resonance Device Cc: Bcc: Energy_Send_List X-Attachments: I want to find out who the primary contact is on this new "over-unity" device: I recently saw a video about it. The device is composed of circular coils of wire, on one planar frame, with one coil inside the other, like two concentric rings, and with the addition a one or more permanent magnets that are inserted into the center (or so?) of the inner coil ring. The device has no internal power source (like batteries, etc.). It is supposedly tuned to the 7.23 Hz Earth's EM field. It is shown in 3 sizes: about 10 inches in diameter, larger, and the largest one was about 18-24 inches in diameter. They are placed flat (parallel to the ground) in the air (on a glass table). When the permanent magnet(s) is/are inserted, the secondary coil registers an output of about 80-100 Volts, on a regular VTVM as seen on the tape. The tape calls this Voltage DC, and also says that it is around 5,000 Hz, which of course does not make sense. The interesting thing is that when the output is connected to a regular lamp light bulb, it lights up just fine - so the promoters say see! It lights a 100 Watt bulb, so the Amperage must be 1 Amp...--> wrong... Anyway, keeping in mind the come-ons... On the tape: The smaller unit lights up one 100 Watt light bulb, and the largest unit lights up ten 100 Watt light bulbs connected in series. And - when the device is operating, they say it has a resistance to any lateral or rotational motion, like a gyroscope has that same resistance to a rotational (only) motion - so - dum de dum dum - there are forces akin to UFO researcher's dreams evidently at work... Also, when the magnet(s) is/are removed, the device does not function as well, and also, when the magnets are in and the device is turned up-side-down, it also does not function as well. Obviously, this device has attracted a lot of attention, and it's applications are far-reaching and numerous, battery-powered cars and lap-tops to name just a few... I have also heard that the inventor has an established lawyer, that they are very stand-off-ish, and that they want A LOT of money up-front (like a ridiculous amount) for this device. So: Two Questions: 1. Who is the primary contact for this device? and 2. Who do we know that can also obtain this same knowledge from other persons, channeled information, or Divine Sources? Please let me know if you have any solid information on this device or its operational physics. All I have is two phone numbers that lead to a dead end. No questions. This is all I know for now. Thanks!
Email received later
and arrangements have just been made to share it:
Patrick, [snip] He wanted US$25 million up front for the secret. We are aware of the concept and have been designing our own version [snip]. He is VERY paranoid about publicity; [snip]. The outer toroidal coil overheats and has no magic factors inside it other than a length of the coil which is cut until resonance is established. In the core of this outer toroidal coil is the instrument package. A magnet is used and a resonance is established using the mechanical (Lorentz) forces developed in the coil. The system pulses with a DC component. Tuning is a function of the coil mass and cross-sectional aspect ratio. It appears an elliptical cross-section is required in the coil. The converter package in the center of the toridal coil appears to be a circuit to convert the pulsed DC component to AC. This whole device is a low-voltage, low frequency, high-current form of the high-voltage, high frequency, low current Moray device. Each system has its good and bad points.... We are working very hard to develop a working model ASAP. We have enough funding and adequate lab facilities [snip]. When and if we have a good working prototype and adequate stocks for immediate market penetration we will let you know. We have a plan which is diametrically opposed to what might be expected [snip] Be patient and use the clues we have shared with you.... Your friends ...[snip]
Telephone Call details received sometime this year:
For lack of any name, it is being called the "Stevens" device.
The name has no connection with anyone or anything, and is just a label.
The videotape (described above) has been around for about 1 & 1/2 to 2 years, not the 1 & 1/2 months that the INE was led to believe.
The device is being promoted by a group who wants a LOT of money for it, and wishes to maintain unknown for obvious reasons.
The device works, and no trickery has been found thus far.
Bailing wire was used in the smaller device.
The placement of the magnets are important and strategic.
The effect seen on the video is powerful; however, lighting a 100 Watt light bulb does not necessarily mean that the device is generating 100 Watts of electrical power.
The device overheats with time. This is an engineering problem that should be easy to solve by a good engineer with assistance from the inventor.
Arrangements are being made to test and develop better prototypes.
The INE will be contacted when new and better videos are available.
That's all we have for you for now.
Return to the INE Main Page
Jan. 12, 1997.